Circuit Documentation

Summary

This circuit consists of an Arduino UNO microcontroller, a red LED, and a 200 Ohm resistor. The LED is connected to the Arduino UNO and is controlled by a simple Arduino sketch that makes the LED blink on and off with a delay.

Component List

Arduino UNO

• Description: A microcontroller board based on the ATmega328P.
• Pins: UNUSED, IOREF, Reset, 3.3V, 5V, GND, Vin, A0, A1, A2, A3, A4, A5, SCL, SDA, AREF, D13, D12, D11, D10, D9, D8, D7, D6, D5, D4, D3, D2, D1, D0

LED: Two Pin (red)

• Description: A red light-emitting diode.
• Pins: cathode, anode

Resistor

• Description: A resistor with a resistance of 200 Ohms.
• Pins: pin1, pin2
• Properties:
  • Resistance: 200 Ohms

Wiring Details

Arduino UNO

• GND: Connected to pin2 of the Resistor.
• D11: Connected to the cathode of the LED.

LED: Two Pin (red)

• cathode: Connected to pin D11 of the Arduino UNO.
• anode: Connected to pin1 of the Resistor.

Resistor

• pin1: Connected to the anode of the LED.
• pin2: Connected to GND of the Arduino UNO.

Code

/*
 * This Arduino Sketch controls an LED connected to pin D11.
 * The LED will blink on and off with a delay of 1 second.
 */

void setup() {
  // Initialize digital pin D11 as an output.
  pinMode(11, OUTPUT);
}

void loop() {
  // Turn the LED on (HIGH is the voltage level)
  digitalWrite(11, HIGH);
  // Wait for a second
  delay(3000);
  // Turn the LED off by making the voltage LOW
  digitalWrite(11, LOW);
  // Wait for a second
  delay(500);
}

This code initializes pin D11 as an output and then enters a loop where it turns the LED on and off with a delay of 3 seconds and 0.5 seconds, respectively.