Circuit Documentation

Summary

This circuit consists of an Arduino UNO microcontroller, a potentiometer, and a resistor. The potentiometer is used to provide an analog input to the Arduino, while the resistor is connected to one of the digital pins of the Arduino.

Component List

Arduino UNO

• Description: A microcontroller board based on the ATmega328P.
• Pins: UNUSED, IOREF, Reset, 3.3V, 5V, GND, Vin, A0, A1, A2, A3, A4, A5, SCL, SDA, AREF, D13, D12, D11, D10, D9, D8, D7, D6, D5, D4, D3, D2, D1, D0

Potentiometer

• Description: A three-terminal resistor with a sliding or rotating contact that forms an adjustable voltage divider.
• Pins: GND, Output, VCC

Resistor

• Description: A passive electrical component with a specific resistance value.
• Pins: pin1, pin2
• Properties:
  • Resistance: 200 Ohms

Wiring Details

Arduino UNO

• 5V: Connected to VCC of the Potentiometer
• GND: Connected to GND of the Potentiometer
• A0: Connected to Output of the Potentiometer
• D13: Connected to pin2 of the Resistor

Potentiometer

• VCC: Connected to 5V of the Arduino UNO
• GND: Connected to GND of the Arduino UNO
• Output: Connected to A0 of the Arduino UNO

Resistor

• pin2: Connected to D13 of the Arduino UNO

Code Documentation

Arduino UNO Code

sketch.ino

void setup() {
  // put your setup code here, to run once:

}

void loop() {
  // put your main code here, to run repeatedly:

}

documentation.txt