Circuit Documentation

Summary

This circuit consists of a 5-channel IR sensor connected to an Arduino Nano. The IR sensor detects infrared signals and sends the data to the Arduino Nano for processing. The Arduino Nano is programmed to handle the input from the IR sensor and can be further programmed to perform specific tasks based on the sensor data.

Component List

5 Channel IR Sensor

• Description: An infrared sensor module with 5 channels for detecting IR signals.
• Pins: VCC, GND, S1, S2, S3, S4, S5, CLP, Near

Arduino Nano

• Description: A small, complete, and breadboard-friendly microcontroller board based on the ATmega328P.
• Pins: D1/TX, D0/RX, RESET, GND, D2, D3, D4, D5, D6, D7, D8, D9, D10, D11/MOSI, D12/MISO, VIN, 5V, A7, A6, A5, A4, A3, A2, A1, A0, AREF, 3V3, D13/SCK

Wiring Details

5 Channel IR Sensor

• VCC: Connected to Arduino Nano 5V
• GND: Connected to Arduino Nano GND
• S1: Connected to Arduino Nano D2
• S2: Connected to Arduino Nano D3
• S3: Connected to Arduino Nano D4
• S4: Connected to Arduino Nano D5
• S5: Connected to Arduino Nano D6

Arduino Nano

• 5V: Connected to 5 Channel IR Sensor VCC
• GND: Connected to 5 Channel IR Sensor GND
• D2: Connected to 5 Channel IR Sensor S1
• D3: Connected to 5 Channel IR Sensor S2
• D4: Connected to 5 Channel IR Sensor S3
• D5: Connected to 5 Channel IR Sensor S4
• D6: Connected to 5 Channel IR Sensor S5

Code Documentation

Arduino Nano Code

void setup() {
  // put your setup code here, to run once:

}

void loop() {
  // put your main code here, to run repeatedly:

}

This code is a basic template for the Arduino Nano. The setup() function is where you initialize your settings, and the loop() function is where you place the main code that runs repeatedly. You can add your specific logic to handle the input from the 5-channel IR sensor in these functions.