Circuit Documentation

Summary

This circuit consists of an Arduino UNO microcontroller connected to three LEDs (red, green, and yellow) through resistors. The LEDs are controlled by the Arduino's digital pins, and the resistors are used to limit the current flowing through the LEDs.

Component List

1. Arduino UNO

   • Description: A microcontroller board based on the ATmega328P.
   • Pins: UNUSED, IOREF, Reset, 3.3V, 5V, GND, Vin, A0, A1, A2, A3, A4, A5, SCL, SDA, AREF, D13, D12, D11, D10, D9, D8, D7, D6, D5, D4, D3, D2, D1, D0

2. Resistor (200 Ohms)

   • Description: A resistor with a resistance of 200 Ohms.
   • Pins: pin1, pin2

3. LED: Two Pin (red)

   • Description: A red LED with two pins.
   • Pins: cathode, anode

4. LED: Two Pin (green)

   • Description: A green LED with two pins.
   • Pins: cathode, anode

5. LED: Two Pin (yellow)

   • Description: A yellow LED with two pins.
   • Pins: cathode, anode

Wiring Details

Arduino UNO

• GND is connected to:

  • Resistor pin2 (200 Ohms)
  • Resistor pin2 (200 Ohms)
  • Resistor pin2 (200 Ohms)

• D5 is connected to:

  • LED (red) anode

• D4 is connected to:

  • LED (yellow) anode

• D3 is connected to:

  • LED (green) anode

Resistor (200 Ohms)

• pin1 is connected to:

  • LED (red) cathode

• pin2 is connected to:

  • Arduino UNO GND

---

• pin1 is connected to:

  • LED (yellow) cathode

• pin2 is connected to:

  • Arduino UNO GND

---

• pin1 is connected to:

  • LED (green) cathode

• pin2 is connected to:

  • Arduino UNO GND

LED: Two Pin (red)

• anode is connected to:

  • Arduino UNO D5

• cathode is connected to:

  • Resistor pin1 (200 Ohms)

LED: Two Pin (green)

• anode is connected to:

  • Arduino UNO D3

• cathode is connected to:

  • Resistor pin1 (200 Ohms)

LED: Two Pin (yellow)

• anode is connected to:

  • Arduino UNO D4

• cathode is connected to:

  • Resistor pin1 (200 Ohms)

Code Documentation

Arduino UNO Code

void setup() {
  // put your setup code here, to run once:

}

void loop() {
  // put your main code here, to run repeatedly:

}

This code is a basic template for the Arduino UNO. The setup() function is where you initialize your settings, and the loop() function is where you place the code that you want to run repeatedly. In this case, the code is empty and does not perform any actions.