Circuit Documentation

Summary

This circuit involves two Arduino UNO microcontrollers, a Servo motor, and an HC-05 Bluetooth module. The circuit is designed to control the Servo motor using signals from the Arduino UNO, which in turn can be controlled via Bluetooth communication through the HC-05 module.

Component List

Arduino UNO

• Description: A microcontroller board based on the ATmega328P.
• Pins: UNUSED, IOREF, Reset, 3.3V, 5V, GND, Vin, A0, A1, A2, A3, A4, A5, SCL, SDA, AREF, D13, D12, D11, D10, D9, D8, D7, D6, D5, D4, D3, D2, D1, D0

Servo

• Description: A motor that can be controlled to move to a specific position.
• Pins: gnd, vcc, pulse

HC-05 Bluetooth Module

• Description: A Bluetooth module used for wireless communication.
• Pins: Key, VCC, TXD, RXD, State, GND

Wiring Details

Arduino UNO (1)

• 5V: Connected to Servo (vcc)
• GND: Connected to Servo (gnd)
• GND: Connected to HC-05 Bluetooth Module (GND)
• Vin: Connected to HC-05 Bluetooth Module (VCC)
• D11: Connected to HC-05 Bluetooth Module (RXD)
• D10: Connected to HC-05 Bluetooth Module (TXD)
• D9: Connected to Servo (pulse)

Arduino UNO (2)

• No connections specified in the net list.

Servo

• vcc: Connected to Arduino UNO (5V)
• gnd: Connected to Arduino UNO (GND)
• pulse: Connected to Arduino UNO (D9)

HC-05 Bluetooth Module

• GND: Connected to Arduino UNO (GND)
• VCC: Connected to Arduino UNO (Vin)
• RXD: Connected to Arduino UNO (D11)
• TXD: Connected to Arduino UNO (D10)

Code Documentation

Arduino UNO (1)

void setup() {
  // put your setup code here, to run once:

}

void loop() {
  // put your main code here, to run repeatedly:

}

Arduino UNO (2)

void setup() {
  // put your setup code here, to run once:

}

void loop() {
  // put your main code here, to run repeatedly:

}

This documentation provides a comprehensive overview of the circuit, including a summary, detailed component list, wiring details, and the code used for the microcontrollers.