Circuit Documentation

Summary

This circuit involves an Arduino UNO microcontroller connected to an SD card module. The Arduino UNO provides power and communicates with the SD card module using SPI (Serial Peripheral Interface) protocol.

Component List

Arduino UNO

• Description: A microcontroller board based on the ATmega328P.
• Pins: UNUSED, IOREF, Reset, 3.3V, 5V, GND, Vin, A0, A1, A2, A3, A4, A5, SCL, SDA, AREF, D13, D12, D11, D10, D9, D8, D7, D6, D5, D4, D3, D2, D1, D0

SD Module

• Description: A module used to interface with SD cards.
• Pins: CS, SCK, MOSI, MISO, VCC, GND

Wiring Details

Arduino UNO

• 5V: Connected to SD Module VCC
• GND: Connected to SD Module GND
• D13: Connected to SD Module SCK
• D12: Connected to SD Module MISO
• D11: Connected to SD Module MOSI
• D10: Connected to SD Module CS

SD Module

• VCC: Connected to Arduino UNO 5V
• GND: Connected to Arduino UNO GND
• SCK: Connected to Arduino UNO D13
• MISO: Connected to Arduino UNO D12
• MOSI: Connected to Arduino UNO D11
• CS: Connected to Arduino UNO D10

Documented Code

Arduino UNO Code (sketch.ino)

void setup() {
  // put your setup code here, to run once:

}

void loop() {
  // put your main code here, to run repeatedly:

}

Additional Documentation (documentation.txt)

This documentation provides a comprehensive overview of the circuit, including a summary, detailed component list, wiring details, and the code used in the microcontroller.