Circuit Documentation

Summary

This document provides a detailed overview of a circuit that includes an Arduino UNO microcontroller, a Muscle BioAmp Candy sensor, and a Pushbutton. The circuit is designed to interface the Muscle BioAmp Candy sensor with the Arduino UNO for signal processing and control via the pushbutton.

Component List

Arduino UNO

• Description: A microcontroller board based on the ATmega328P.
• Pins: UNUSED, IOREF, Reset, 3.3V, 5V, GND, Vin, A0, A1, A2, A3, A4, A5, SCL, SDA, AREF, D13, D12, D11, D10, D9, D8, D7, D6, D5, D4, D3, D2, D1, D0

Muscle BioAmp Candy

• Description: A sensor module used for amplifying bioelectric signals.
• Pins: out, gnd, vcc, ref, in+, in-

Pushbutton

• Description: A simple pushbutton switch.
• Pins: Pin 3 (out), Pin 4 (out), Pin 1 (in), Pin 2 (in)

Wiring Details

Arduino UNO

• 5V: Connected to Muscle BioAmp Candy vcc
• GND: Connected to Muscle BioAmp Candy gnd
• A0: Connected to Muscle BioAmp Candy out

Muscle BioAmp Candy

• vcc: Connected to Arduino UNO 5V
• gnd: Connected to Arduino UNO GND
• out: Connected to Arduino UNO A0
• ref: Connected to Pushbutton Pin 2 (in)
• in+: Connected to Pushbutton Pin 4 (out)
• in-: Connected to Pushbutton Pin 3 (out)

Pushbutton

• Pin 2 (in): Connected to Muscle BioAmp Candy ref
• Pin 4 (out): Connected to Muscle BioAmp Candy in+
• Pin 3 (out): Connected to Muscle BioAmp Candy in-

Code Documentation

Arduino UNO Code

sketch.ino

void setup() {
  // put your setup code here, to run once:

}

void loop() {
  // put your main code here, to run repeatedly:

}

documentation.txt