Circuit Documentation

Summary

This circuit consists of an Arduino UNO microcontroller, a red LED, and a resistor. The Arduino UNO controls the LED, making it blink on and off with a delay of one second. The resistor is used to limit the current flowing through the LED to prevent damage.

Component List

Arduino UNO

• Description: A microcontroller board based on the ATmega328P.
• Pins: UNUSED, IOREF, Reset, 3.3V, 5V, GND, Vin, A0, A1, A2, A3, A4, A5, SCL, SDA, AREF, D13, D12, D11, D10, D9, D8, D7, D6, D5, D4, D3, D2, D1, D0

LED: Two Pin (red)

• Description: A red light-emitting diode.
• Pins: cathode, anode

Resistor

• Description: A resistor with a resistance of 200 Ohms.
• Pins: pin1, pin2
• Properties:
  • Resistance: 200 Ohms

Wiring Details

Arduino UNO

• GND: Connected to pin1 of the Resistor.
• D13: Connected to the anode of the LED.

LED: Two Pin (red)

• anode: Connected to D13 of the Arduino UNO.
• cathode: Not connected in the provided net list.

Resistor

• pin1: Connected to GND of the Arduino UNO.
• pin2: Not connected in the provided net list.

Code Documentation

Arduino UNO Code

// Define the pin for the LED
const int ledPin = 13;

void setup() {
  // Initialize the digital pin as an output.
  pinMode(ledPin, OUTPUT);
}

void loop() {
  // Turn the LED on (HIGH is the voltage level)
  digitalWrite(ledPin, HIGH);
  // Wait for a second
  delay(1000);
  // Turn the LED off by making the voltage LOW
  digitalWrite(ledPin, LOW);
  // Wait for a second
  delay(1000);
}

This code initializes pin 13 of the Arduino UNO as an output pin. In the loop function, it turns the LED on and off with a delay of one second between each state change, making the LED blink.