Circuit Documentation

Summary

This circuit consists of an Arduino UNO microcontroller, a resistor, and a red LED. The Arduino UNO provides power to the LED through the resistor, which limits the current to protect the LED.

Component List

Arduino UNO

• Description: A microcontroller board based on the ATmega328P.
• Pins: UNUSED, IOREF, Reset, 3.3V, 5V, GND, Vin, A0, A1, A2, A3, A4, A5, SCL, SDA, AREF, D13, D12, D11, D10, D9, D8, D7, D6, D5, D4, D3, D2, D1, D0

Resistor

• Description: A passive electrical component that implements electrical resistance as a circuit element.
• Pins: pin1, pin2
• Properties:
  • Resistance: 200 Ohms

LED: Two Pin (red)

• Description: A light-emitting diode that emits red light.
• Pins: cathode, anode

Wiring Details

Arduino UNO

• 5V: Connected to Resistor pin1
• GND: Connected to LED cathode

Resistor

• pin1: Connected to Arduino UNO 5V
• pin2: Connected to LED anode

LED: Two Pin (red)

• cathode: Connected to Arduino UNO GND
• anode: Connected to Resistor pin2

Code Documentation

Arduino UNO Code

void setup() {
  // put your setup code here, to run once:

}

void loop() {
  // put your main code here, to run repeatedly:

}

This code is a basic template for the Arduino UNO. The setup() function is called once when the program starts and is used to initialize any settings. The loop() function runs continuously after setup() and is used to execute the main logic of the program. Currently, both functions are empty and can be filled with the desired functionality for the circuit.