Circuit Documentation

Summary

This circuit involves an Arduino UNO microcontroller interfacing with a DHT11 temperature and humidity sensor and an LM35DT temperature sensor. The Arduino UNO provides power to the sensors and reads data from them. The DHT11 sensor is connected to a digital pin, while the LM35DT sensor is connected to an analog pin.

Component List

Arduino UNO

• Description: A microcontroller board based on the ATmega328P.
• Pins: UNUSED, IOREF, Reset, 3.3V, 5V, GND, Vin, A0, A1, A2, A3, A4, A5, SCL, SDA, AREF, D13, D12, D11, D10, D9, D8, D7, D6, D5, D4, D3, D2, D1, D0

DHT11

• Description: A digital temperature and humidity sensor.
• Pins: DATA, GND, VCC

LM35DT

• Description: An analog temperature sensor.
• Pins: Vs, GND, OUT

Wiring Details

Arduino UNO

• 5V: Connected to Vs of LM35DT
• GND: Connected to GND of LM35DT and GND of DHT11
• A1: Connected to OUT of LM35DT
• D6: Connected to DATA of DHT11

DHT11

• DATA: Connected to D6 of Arduino UNO
• GND: Connected to GND of Arduino UNO
• VCC: Not connected

LM35DT

• Vs: Connected to 5V of Arduino UNO
• GND: Connected to GND of Arduino UNO
• OUT: Connected to A1 of Arduino UNO

Code

Arduino UNO Code (sketch.ino)

void setup() {
  // put your setup code here, to run once:

}

void loop() {
  // put your main code here, to run repeatedly:

}

Documentation (documentation.txt)

This documentation provides a comprehensive overview of the circuit, including a summary, detailed component list, wiring details, and the code used in the Arduino UNO microcontroller.