Circuit Documentation

Summary

This circuit consists of an Arduino UNO microcontroller, a 220 Ohm resistor, and a red LED. The Arduino UNO controls the LED, which is connected through the resistor to limit the current.

Component List

Arduino UNO

• Description: A microcontroller board based on the ATmega328P.
• Pins: UNUSED, IOREF, Reset, 3.3V, 5V, GND, Vin, A0, A1, A2, A3, A4, A5, SCL, SDA, AREF, D13, D12, D11, D10, D9, D8, D7, D6, D5, D4, D3, D2, D1, D0
• Purpose in Circuit: Acts as the main controller for the circuit.

Resistor

• Description: A 220 Ohm resistor.
• Pins: pin1, pin2
• Properties:
  • Resistance: 220 Ohms
• Purpose in Circuit: Limits the current flowing through the LED to prevent damage.

LED: Two Pin (red)

• Description: A red LED with two pins.
• Pins: cathode, anode
• Purpose in Circuit: Provides visual feedback by lighting up when powered.

Wiring Details

Arduino UNO

• GND: Connected to pin1 of the Resistor.
• D13: Connected to the anode of the LED.

Resistor

• pin1: Connected to GND of the Arduino UNO.
• pin2: Connected to the cathode of the LED.

LED: Two Pin (red)

• anode: Connected to D13 of the Arduino UNO.
• cathode: Connected to pin2 of the Resistor.

Documented Code

sketch.ino

void setup() {
  // put your setup code here, to run once:

}

void loop() {
  // put your main code here, to run repeatedly:

}

documentation.txt