Circuit Documentation
Summary
This circuit integrates various sensors with an Arduino UNO R4 WiFi microcontroller to measure environmental parameters such as temperature, TDS (Total Dissolved Solids), and pH levels. The sensors are powered by the Arduino's 5V output and share a common ground. Sensor outputs are connected to the Arduino's analog and digital inputs for data acquisition. A resistor is used in conjunction with the DS18B20 temperature sensor for signal conditioning.
Component List
- Sonda Sensor TDS: A sensor used to measure the total dissolved solids in a liquid.
- DS18B20: A digital temperature sensor that provides temperature readings in Celsius.
- TDS Sensor: A sensor designed to measure the total dissolved solids in water.
- Resistor (4.7 Ohms): A passive two-terminal electrical component that implements electrical resistance as a circuit element.
- pH Degree Sensor Module: A sensor module used to measure the pH level of a liquid.
- Modulo Sensor TDS: Another sensor module for measuring total dissolved solids in a liquid.
- Sonda Sensor Turbidez / Turbidity: A sensor used to measure the turbidity or cloudiness of a liquid.
- Arduino UNO R4 WiFi: A microcontroller board based on the ATmega328, with integrated WiFi capabilities.
- Comment: A placeholder for additional notes or comments in the circuit design.
Wiring Details
Sonda Sensor TDS
+connected to TDS SensorP2-connected to TDS SensorP1
DS18B20
vccconnected to 5V power supplyGNDconnected to common groundsignalconnected to Arduino UNO R4 WiFiD2through a 4.7 Ohms resistor
TDS Sensor
+connected to 5V power supply-connected to common groundAconnected to Arduino UNO R4 WiFiA0
Resistor (4.7 Ohms)
pin1connected to 5V power supplypin2connected to DS18B20signal
pH Degree Sensor Module
pH Positiveconnected to 5V power supplypH Negativeconnected to common groundpH Aconnected to Arduino UNO R4 WiFiA2
Modulo Sensor TDS
+connected to 5V power supply and Sonda Sensor Turbidez / Turbidity+-connected to common ground and Sonda Sensor Turbidez / Turbidity-Aconnected to Arduino UNO R4 WiFiA1
Sonda Sensor Turbidez / Turbidity
+connected to 5V power supply-connected to common ground
Arduino UNO R4 WiFi
5Vconnected to DS18B20vcc, TDS Sensor+, Resistorpin1, and pH Degree Sensor ModulepH PositiveGNDconnected to DS18B20GND, TDS Sensor-, Modulo Sensor TDS-, and pH Degree Sensor ModulepH NegativeA0connected to TDS SensorAA1connected to Modulo Sensor TDSAA2connected to pH Degree Sensor ModulepH AD2connected to DS18B20signal
Documented Code
Arduino UNO R4 WiFi - sketch.ino
void setup() {
// put your setup code here, to run once:
}
void loop() {
// put your main code here, to run repeatedly:
}
Arduino UNO R4 WiFi - documentation.txt
(No additional documentation provided)
