Circuit Documentation

Summary

This circuit consists of an Arduino UNO microcontroller interfaced with an HX711 Bridge Sensor Interface. The HX711 is used to interface with a load cell, and the Arduino UNO processes the data from the HX711. The circuit is powered by the 5V supply from the Arduino UNO.

Component List

Arduino UNO

• Description: A microcontroller board based on the ATmega328P.
• Pins: UNUSED, IOREF, Reset, 3.3V, 5V, GND, Vin, A0, A1, A2, A3, A4, A5, SCL, SDA, AREF, D13, D12, D11, D10, D9, D8, D7, D6, D5, D4, D3, D2, D1, D0

HX711 - Bridge Sensor Interface

• Description: A precision 24-bit analog-to-digital converter (ADC) designed for weigh scales and industrial control applications to interface directly with a bridge sensor.
• Pins: E+, E-, A-, A+, B-, B+, GND - GROUND, DATA (OUT), SCK - CLOCK (IN), 3.3/3.5V Supply

Wiring Details

Arduino UNO

• GND: Connected to GND - GROUND of HX711
• D2: Connected to DATA (OUT) of HX711
• D3: Connected to SCK - CLOCK (IN) of HX711
• 5V: Connected to 3.3/3.5V Supply of HX711

HX711 - Bridge Sensor Interface

• GND - GROUND: Connected to GND of Arduino UNO
• DATA (OUT): Connected to D2 of Arduino UNO
• SCK - CLOCK (IN): Connected to D3 of Arduino UNO
• 3.3/3.5V Supply: Connected to 5V of Arduino UNO

Code Documentation

Arduino UNO Code

sketch.ino

void setup() {
  // put your setup code here, to run once:

}

void loop() {
  // put your main code here, to run repeatedly:

}

documentation.txt

This documentation provides a comprehensive overview of the circuit, including a summary, detailed component descriptions, wiring details, and the code used in the Arduino UNO.