Circuit Documentation

Summary

This document provides a detailed overview of a simple circuit involving an Arduino UNO, a pushbutton, and a resistor. The circuit is designed to demonstrate basic input and output operations using the Arduino platform.

Component List

Arduino UNO

• Description: A microcontroller board based on the ATmega328P.
• Pins: UNUSED, IOREF, Reset, 3.3V, 5V, GND, Vin, A0, A1, A2, A3, A4, A5, SCL, SDA, AREF, D13, D12, D11, D10, D9, D8, D7, D6, D5, D4, D3, D2, D1, D0

Pushbutton

• Description: A simple pushbutton switch.
• Pins: Pin 3 (out), Pin 4 (out), Pin 1 (in), Pin 2 (in)

Resistor

• Description: A resistor with a resistance of 200 Ohms.
• Pins: pin1, pin2
• Properties:
  • Resistance: 200 Ohms

Wiring Details

Arduino UNO

• GND is connected to pin1 of the Resistor.
• D9 is connected to Pin 1 (in) of the Pushbutton.
• 5V is connected to Pin 4 (out) of the Pushbutton.

Pushbutton

• Pin 1 (in) is connected to D9 of the Arduino UNO.
• Pin 4 (out) is connected to 5V of the Arduino UNO.
• Pin 2 (in) is connected to pin2 of the Resistor.

Resistor

• pin1 is connected to GND of the Arduino UNO.
• pin2 is connected to Pin 2 (in) of the Pushbutton.

Documented Code

Arduino UNO Code

void setup() {
  // put your setup code here, to run once:

}

void loop() {
  // put your main code here, to run repeatedly:

}

This code is a basic template for the Arduino UNO. The setup() function is where you initialize your settings, and the loop() function is where you place the main code that runs repeatedly.

Additional Documentation

This section is reserved for any additional documentation or notes related to the circuit and its operation.