Circuit Documentation

Summary

This circuit consists of an Arduino UNO microcontroller, a red LED, and a resistor. The LED is powered by the 5V output of the Arduino and is connected to ground through the resistor. The Arduino is programmed to control the circuit.

Component List

Arduino UNO

• Description: A microcontroller board based on the ATmega328P.
• Pins: UNUSED, IOREF, Reset, 3.3V, 5V, GND, Vin, A0, A1, A2, A3, A4, A5, SCL, SDA, AREF, D13, D12, D11, D10, D9, D8, D7, D6, D5, D4, D3, D2, D1, D0
• Purpose in Circuit: Acts as the main controller for the circuit.

LED: Two Pin (red)

• Description: A red light-emitting diode.
• Pins: cathode, anode
• Purpose in Circuit: Provides visual indication when powered.

Resistor

• Description: A resistor with a resistance of 200 Ohms.
• Pins: pin1, pin2
• Properties:
  • Resistance: 200 Ohms
• Purpose in Circuit: Limits the current flowing through the LED to prevent damage.

Wiring Details

Arduino UNO

• 5V Pin: Connected to the anode of the LED.
• GND Pin: Connected to pin1 of the resistor.

LED: Two Pin (red)

• Anode: Connected to the 5V pin of the Arduino.
• Cathode: Connected to pin2 of the resistor.

Resistor

• Pin1: Connected to the GND pin of the Arduino.
• Pin2: Connected to the cathode of the LED.

Documented Code

sketch.ino

void setup() {
  // put your setup code here, to run once:

}

void loop() {
  // put your main code here, to run repeatedly:

}

documentation.txt