Circuit Documentation

Summary

This circuit consists of an Arduino UNO microcontroller, a red LED, and a 220 Ohm resistor. The LED is connected to the Arduino through the resistor, allowing the Arduino to control the LED.

Component List

Arduino UNO

• Description: A microcontroller board based on the ATmega328P.
• Pins: UNUSED, IOREF, Reset, 3.3V, 5V, GND, Vin, A0, A1, A2, A3, A4, A5, SCL, SDA, AREF, D13, D12, D11, D10, D9, D8, D7, D6, D5, D4, D3, D2, D1, D0

LED: Two Pin (red)

• Description: A red light-emitting diode.
• Pins: cathode, anode

Resistor

• Description: A resistor with a resistance of 220 Ohms.
• Pins: pin1, pin2
• Properties:
  • Resistance: 220 Ohms

Wiring Details

Arduino UNO

• GND: Connected to the cathode of the LED.
• D9: Connected to pin2 of the resistor.

LED: Two Pin (red)

• cathode: Connected to GND of the Arduino.
• anode: Connected to pin1 of the resistor.

Resistor

• pin1: Connected to the anode of the LED.
• pin2: Connected to D9 of the Arduino.

Code

Arduino UNO Code (sketch.ino)

void setup() {
  // put your setup code here, to run once:

}

void loop() {
  // put your main code here, to run repeatedly:

}

Documentation (documentation.txt)

This documentation provides a comprehensive overview of the circuit, including a summary, detailed component descriptions, wiring details, and the code used for the Arduino UNO microcontroller.