Cirkit Designer LogoCirkit DesignerYour all-in-one circuit design IDE Launch Cirkit Designer App

Arduino Nano Controlled LED Array with Resistors

View and Edit Project In Cirkit DesignerImage of Arduino Nano Controlled LED Array with Resistors

Circuit Documentation

Summary

This circuit consists of an Arduino Nano microcontroller connected to multiple red LEDs through resistors. Each LED is controlled by a different digital pin on the Arduino Nano. The resistors are used to limit the current flowing through the LEDs to prevent damage.

Component List

  1. Arduino Nano

    • Description: A small, complete, and breadboard-friendly board based on the ATmega328P.
    • Pins: D1/TX, D0/RX, RESET, GND, D2, D3, D4, D5, D6, D7, D8, D9, D10, D11/MOSI, D12/MISO, VIN, 5V, A7, A6, A5, A4, A3, A2, A1, A0, AREF, 3V3, D13/SCK

  2. Resistor (200 Ohms)

    • Description: A passive electrical component that implements electrical resistance as a circuit element.
    • Pins: pin1, pin2

  3. LED: Two Pin (red)

    • Description: A light-emitting diode that emits red light.
    • Pins: cathode, anode

Wiring Details

Arduino Nano

Resistor (200 Ohms)

LED: Two Pin (red)

Code Documentation

Arduino Nano Code

void setup() {
  // put your setup code here, to run once:

}

void loop() {
  // put your main code here, to run repeatedly:

}

This code is a basic template for the Arduino Nano. The setup() function is where you initialize your settings, and the loop() function is where you place the main code that runs repeatedly.

Additional Documentation

This section is reserved for any additional documentation or notes related to the code or circuit.