Circuit Documentation

Summary

This circuit consists of an Arduino UNO microcontroller, a water sensor, and a plastic solenoid valve. The Arduino UNO is used to read the water sensor's signal and control the solenoid valve based on the sensor's input.

Component List

Arduino UNO

• Description: A microcontroller board based on the ATmega328P.
• Pins: UNUSED, IOREF, Reset, 3.3V, 5V, GND, Vin, A0, A1, A2, A3, A4, A5, SCL, SDA, AREF, D13, D12, D11, D10, D9, D8, D7, D6, D5, D4, D3, D2, D1, D0

Water Sensor

• Description: A sensor used to detect the presence of water.
• Pins: Signal, VCC, GND

Plastic Solenoid Valve

• Description: An electrically controlled valve used to control the flow of liquids.
• Pins: pin1, pin2

Wiring Details

Arduino UNO

• 5V: Connected to VCC of the Water Sensor
• GND: Connected to GND of the Water Sensor and pin1 of the Plastic Solenoid Valve
• D10: Connected to pin2 of the Plastic Solenoid Valve
• D6: Connected to Signal of the Water Sensor

Water Sensor

• VCC: Connected to 5V of the Arduino UNO
• GND: Connected to GND of the Arduino UNO
• Signal: Connected to D6 of the Arduino UNO

Plastic Solenoid Valve

• pin1: Connected to GND of the Arduino UNO
• pin2: Connected to D10 of the Arduino UNO

Code Documentation

Arduino UNO Code

sketch.ino

void setup() {
  // put your setup code here, to run once:

}

void loop() {
  // put your main code here, to run repeatedly:

}

documentation.txt

This documentation provides a comprehensive overview of the circuit, including a summary, detailed component descriptions, wiring details, and the code used in the Arduino UNO.