Circuit Documentation

Summary

This circuit consists of an Arduino UNO microcontroller, a red LED, and a 220 Ohm resistor. The LED is connected to the Arduino through the resistor, and the Arduino is programmed to control the LED.

Component List

LED: Two Pin (red)

• Description: A red LED with two pins: anode and cathode.
• Pins:
  • anode
  • cathode

Arduino UNO

• Description: A microcontroller board based on the ATmega328P.
• Pins:
  • UNUSED
  • IOREF
  • Reset
  • 3.3V
  • 5V
  • GND
  • Vin
  • A0
  • A1
  • A2
  • A3
  • A4
  • A5
  • SCL
  • SDA
  • AREF
  • D13
  • D12
  • D11
  • D10
  • D9
  • D8
  • D7
  • D6
  • D5
  • D4
  • D3
  • D2
  • D1
  • D0

Resistor

• Description: A resistor with a resistance of 220 Ohms.
• Pins:
  • pin1
  • pin2
• Properties:
  • Resistance: 220 Ohms

Wiring Details

LED: Two Pin (red)

• anode is connected to pin2 of the Resistor.
• cathode is connected to GND of the Arduino UNO.

Arduino UNO

• D13 is connected to pin1 of the Resistor.
• GND is connected to cathode of the LED.

Resistor

• pin1 is connected to D13 of the Arduino UNO.
• pin2 is connected to anode of the LED.

Code Documentation

Arduino UNO Code

void setup() {
  // put your setup code here, to run once:

}

void loop() {
  // put your main code here, to run repeatedly:

}

Additional Documentation

This documentation provides a comprehensive overview of the circuit, including a summary, detailed component descriptions, wiring details, and the code used for the Arduino UNO.